CRK 240
Factory-Original SU Rebuild kit for a SU H6 THERMO carburetor.
This is the most elaborate rebuild kit available for the SU H6 Th.
This set contains the following parts to service ONE carburetor:
- Throttle Valve
- 2 Throttle Valve Screws
- Throttle Shaft
- 2 x Throttle Shaft Bushing
- Jet
- Air filter gasket
- Inlet manifold gaskets
- Needle valve + seat
- Float Hinge Pin
- Various o-rings
- Float chamber gasket
- Various other washers and seals
Please note that the photograph is leading as that illustrates most clearly what is contained in this set.
Therefore, please compare your old parts carefully with what you see in the picture.
Important:
This kit contains various items made of cork.
These cork parts need to be soaked in engine oil for at least 24 hours before assembly.
This includes the small, black, cork washers in the small plastic bag.
This is a factory-original SU service kit.
This is SU Article Number: CRK 240 / CRK240
According to SU nomenclature, this is a co-called Rebuild Kit.
Should you be looking for the less elaborate Service Kit or the basic Gasket kit, then please don't hesitate to contact us.
* Made in the UK *
General Notice
SU has been making carburetors (or "Carburetters" as they call them themselves) since 1904 and the number of different models runs in the hundreds.
In order to find the correct part for your specific carburetor, it helps us if you have the so-called "tag number" at hand.
This tag number is usually stamped onto a small aluminum tag found under one of the screws of the float chamber cover like in this photo:
Without this tag number, the search for the correct part is, also for us, rather challenging as most SU carburetors are look-a-likes of each-other and going just by vehicle type still leaves too many options open.
So, feel free to contact us by email if the set or parts that you are looking for is not yet listed but please have this tag number at hand.
Our Contact Page can be found HERE.